Removing Hollowgram arms of all generations (as of model year 2017) are removed with the KT013 crank puller.
- Remove the crank bolt with a 10mm hex wrench.
- Thread the smaller inner piece into the bottom bracket spindle threads using an 8mm hex wrench.
- Thread the outer piece into the crankarm threads until it is tight.
- Use the 8mm wrench to back out the inner piece in the spindle. This will pull the arm off the spindle.
- Remove the threaded piece from the arm.
- These tools are only needed to remove arms and are not used to install an arm on the a spindle.